Machining EV Charger Pedestals, Brackets and Holsters
A charging cable pulled across a parking bay applies a different load to its supporting hardware than the same cable
SPI Class 101 to 105: Matching Tool Life to Your Volume
A worn gate insert should not automatically retire an otherwise serviceable mold. Whether the insert can be replaced, accessed without
Machining Sealed Aluminum Automotive Sensor Housings
A pressure sensor needs a route for the measured pressure to reach its sensing element. The electronics beside it need
H7/g6 vs H7/k6 vs H7/p6: Clearance, Transition and Interference
During a planned machine changeover, a technician must remove a guide sleeve while leaving its housing in place. The replacement
Prototyping Automotive Interior Parts with CNC and Casting
A center-console review can pull a prototype in different directions. Packaging engineers want the bezel to locate against the switch
RAL 7035, 9005 and 9016: The Powder Coats You’ll Use
An equipment cabinet has a new service panel beside its original door. Both carry the same RAL color callout, yet
Machining Copper Busbars for EV Battery Systems
A counterbore gives a fastener room to sit below a busbar’s surface. It also removes copper near the connection. If
Type III Hardcoat Anodizing: Growth and Tolerances
Coat a shaft and its mating bore, and the finish consumes clearance from both directions: the shaft grows while the
Machining Aluminum EV Battery Enclosures and Trays
In a battery tray with integrated cooling, the cover seal and coolant channels form separate pressure boundaries. A passing cover-seal
LSR Shore A 30 vs 50 vs 70: Choosing Hardness for Seals
A buyer asks for the same gasket in three hardnesses and expects the quotations to reveal the best option. Yet
